John Guest Speedfit Underfloor Heating

There packs are the same as the original underfloor heating packs but the pump has been upgraded to an "A Rated" version

2 x 15mm x 100m Coil Polybutylene Pipe
1 x Programmable Room Thermostat
1 x Single Room Control Unit
300 x 15mm Pipe Clips
8 x 15mm Pipe Inserts
2 x 15mm Speedfit Equal Tees
2 x 15mm Speedfit Swivel Elbows

1 x 15mm x 150m Coil Polybutylene Pipe
1 x Single Room Control Unit
1 x Programmable Room Thermostat
200 x 15mm Pipe Clips
2 x 15mm Pipe Inserts

1 x 15mm x 150m Coil Polybutylene Pipe
1 x Single Room Control Unit
1 x Wireless Programmable Room Thermostat

1 x Wireless Receiver

200 x 15mm Pipe Clips
2 x 15mm Pipe Inserts

The new Speedfit Underfloor Heating Control Unit is the ideal way to provide heating to a conservatory or room extension, up to 30m².

The unit is pre-assembled and pre-wired to allow for a fast and simple installation.

Actuator Valves are controlled by a thermostat or programmer. They operate to open or close the flow of water to an individual zone on the manifold.

Used with solid (screeded) floors, Edge insulation Strip is used to create insulation around the edge of a room and to provide an expansion gap for the solid floor as it heats up and cools down.

Hot water is taken from the boiler, mixed to the required temperature and circulated via the manifold to the heating circuits, the temperature and volume of water is constantly altered to maintain the requirements of the system. Flow temperature can be altered by turning the hand wheel on the mixing valve unit.

Enables a pump pack and manifold to be installed at 90° to each other.

From John Guest Speedfit Underfloor

A Manifold Extension Kit enables a manifold to be be extended by one or more zones.